Your Sinch Fax API project is disabled automatically when your Sinch account runs out of available credit. Once your balance is back above zero, the project is re-enabled.
How to tell your project is disabled
You may see any of the following:
- A Fax Project Disabled email saying your project has no available credit.
- A banner on the Fax pages of the Sinch Build Dashboard: Your fax project is disabled.
- This response when you send a fax through the API:
HTTP 403
{"code":403,"status":"forbidden","message":"Project is disabled"}What stops working
While a project is disabled:
- New faxes sent through the API are refused.
- Faxes sent by email are refused.
- Incoming fax calls to your numbers are rejected.
How to re-enable your project
- Log in to the Sinch Build Dashboard and check your balance, which is shown at the top of the page.
- If your balance is not positive, add credit to your account. If your account is still in trial, click Upgrade in the top bar and follow the prompts.
- Wait for the project to re-enable. This can take up to 15 minutes.
- Send a test fax to +19898989898. This test destination behaves like a real fax and is not billed.
You do not need to contact Support to re-enable the project after adding credit.
Why it can happen when you have not sent any faxes
Rented phone numbers are charged every month, even when they are not in use, so your balance can fall without any fax traffic. You can see your numbers under Numbers > Your virtual numbers.
How to avoid it
- Turn on Automatic Recharge and set the threshold well above what you typically spend in a day.
- Set up low-balance notifications so you know before your balance runs out.
Note: Automatic Recharge does not run once your balance is negative. You need to add credit manually. A pending transaction or a failed payment can also stop it. See Why wasn’t the Automatic Recharge activated on my Sinch Account?
If your balance is positive and your project is still disabled
Contact Sinch Support and include your Project ID and the time of the failed request.
I have a new account and see the disabled banner
Contact Sinch Support and include your Project ID.
Comments
0 comments
Please sign in to leave a comment.